" /> Info Mart first transform fails on some userdata check - Genesys CTI User Forum
« previous next »
Pages: 1 [2]   Go Down

Author Topic: Info Mart first transform fails on some userdata check  (Read 9425 times)

Offline imaki

  • Jr. Member
  • **
  • Posts: 51
  • Karma: 0
Re: Info Mart first transform fails on some userdata check
« Reply #15 on: October 22, 2012, 08:06:15 AM »
Advertisement
I also tried to reduce the amount of those columns in that configuration, but now the original error returned.. I'll give up. Hopefully Genesys can sort this out..
Logged

Offline Kubig

  • Hero Member
  • *****
  • Posts: 2755
  • Karma: 44
Re: Info Mart first transform fails on some userdata check
« Reply #16 on: October 22, 2012, 08:20:56 AM »
Try to delete whole GIM dbschema and re-create this again.Check all steps.
Logged

Offline imaki

  • Jr. Member
  • **
  • Posts: 51
  • Karma: 0
Re: Info Mart first transform fails on some userdata check
« Reply #17 on: October 22, 2012, 10:14:00 AM »
I have done that several times. I also recreated the IDBs twice, with no luck..
Logged

Offline Kubig

  • Hero Member
  • *****
  • Posts: 2755
  • Karma: 44
Re: Info Mart first transform fails on some userdata check
« Reply #18 on: October 22, 2012, 11:00:55 AM »
I have installed GIM solution in R8.1 and all works fine. I did several updates of GIM's components and result was always ok. So,may be you use patch with bug or you make a mistake during GIM deployment.
Logged

Offline imaki

  • Jr. Member
  • **
  • Posts: 51
  • Karma: 0
Re: Info Mart first transform fails on some userdata check
« Reply #19 on: November 14, 2012, 07:28:26 AM »
I got solution from Genesys. I had default-schema in the GIM-DAP as 'GIDB.dbo', but it should have been just 'dbo'. After that change initialize-job was ran successfully, and ETL started.

I dont get it, but hopefully this solution helps somebody else some day..
Logged
Pages: 1 [2]   Go Up
« previous next »