" /> Avaya Genesys simple (prolly) question. - Genesys CTI User Forum
« previous next »
Pages: [1]   Go Down

Author Topic: Avaya Genesys simple (prolly) question.  (Read 4425 times)

HowTo

  • Guest
Avaya Genesys simple (prolly) question.
« on: May 06, 2008, 12:02:58 PM »
Advertisement
Hello!
Just one question - probably dumb, but stuck at this point. When configuring options of TServer for AVAYA there is some fields in section link-tcp like "ip", "link number" & "port". The question is - what value for "port" should i use ?  I suppose it is a tcp port which should be administered in DLG application on MAPD. But i don't see any port administration in MAPD. Well I do understand how to do it with Alcatel where the standart port for TAPI exist ( 2555 as I remember). But what about AVAYA ?

Thanks in advance.
Reagrds,
HowTo.
Logged

Offline René

  • Administrator
  • Hero Member
  • *****
  • Posts: 1832
  • Karma: 62
Re: Avaya Genesys simple (prolly) question.
« Reply #1 on: May 06, 2008, 01:38:40 PM »
  • Best Answer
    • Hi,

    Standard port is 5678. I haven't seen Avaya for a while so I don't remember where this port is configured on Avaya side... :(

    R.
    Logged

    HowTo

    • Guest
    Re: Avaya Genesys simple (prolly) question.
    « Reply #2 on: May 06, 2008, 01:41:47 PM »
  • Best Answer
    • Thanks a lot. Simultaneously found ot by myself. :) BTW I also dont't know how to change it using DLG. With Co-Res DLG it seems easy by administering ip-services form - but that is only for S8300.
    Logged

    Offline bcyk

    • Full Member
    • ***
    • Posts: 113
    • Karma: 6
    Re: Avaya Genesys simple (prolly) question.
    « Reply #3 on: May 06, 2008, 03:03:16 PM »
  • Best Answer
    • "brief" information on Avaya MAP-D and DLG configuration is attached (mapd-config.zip) for sharing.

    To configure ASAI-link, you need to configure objects in both switch and MAP-D.

    Have fun!
    Logged
    Pages: [1]   Go Up
    « previous next »