" /> How to get simulator to work with G3 TServer? - Genesys CTI User Forum
« previous next »
Pages: [1]   Go Down

Author Topic: How to get simulator to work with G3 TServer?  (Read 3194 times)

This topic contains a post which is marked as Best Answer. Press here if you would like to see it.

Leftovers

  • Guest
How to get simulator to work with G3 TServer?
« on: January 01, 1970, 12:00:00 AM »
Advertisement
Hi,

I am using G6.5 PBX simulator for G3 and my G3 TServer connects and disconnects from it every 5 seconds. Anyone knows anything about it?
Logged

Eva

  • Guest
How to get simulator to work with G3 TServer?
« Reply #1 on: January 01, 1970, 12:00:00 AM »
What erroe message do you get?
Logged

Vic

  • Guest
How to get simulator to work with G3 TServer?
« Reply #2 on: January 01, 1970, 12:00:00 AM »
Ok, this is a simple problem!
What you need to do is add another option to your Simulator definitions under "Switch" in CME. asaiprotocol ype or something like that and set it to g3.

I am onsite right now and cannot look it up, but will ask someone to write the exact name of the keyword for me.

Logged
Marked as best answer by on Today at 08:14:33 AM

Tony

  • Guest
How to get simulator to work with G3 TServer?
« Reply #3 on: January 01, 1970, 12:00:00 AM »
  • Undo Best Answer
    • I've seen this too, you need to add the following in the switch's Annex tab under the Simulator section:

    Name = ctiprotocolmode
    Value = g3

    Hope this helps,

    Tony
    Logged
    Pages: [1]   Go Up
    « previous next »